negev5021

I just got one from ace case, it holds 4 12 rounders for 20 bucks. I use it to hold 2 (its 2 on one side, 2 on the other, with a should strap) - I use the rear side mag flaps to go around my belt, and the velcro holds it on. I found that hard pouches on your belt put the hi capacity mags way high, so with this one the top of the mag ends up about at belt level.

Just guessing, but is the red dot way low? You may want to add distance between the end of barrel and what the red dot is pointing at...'specially if its a high mount.

Uh, you may want to leave it in.

Thanks everyone for the input - I went with a BP-02.

http://www.midwayusa.com/viewproduct/?productnumber=583331&utm_source=froogle&utm_medium=free&utm_campaign=657 I am having trouble mounting an eotech on my S12. Got the Pro mag side mount, it sat too high, got another side mount that would not stay on, beryl mount would not properly fit after conversion. Looking to mount as far rear on the top cover area as possible, as low as possible and still be able to remove top cover. This one above mounts through the gun, so I would think it would stay on better than throw lever, but I am all ears for a good mount if anyone has a solid o

Here ya go: [EDITED]

Total noob/lurker, but a g36 carry handle/optic would be sweet on that....

Hello all I am a new member but have lurked here for quite some time in an effort to get my Saiga running properly. I have encountered and overcome most all issues in reliability, feeding, -FTE you name it I have had it-and through extensive searching on this site have found the fix to all, so thank you all for your extensive knowledge base! My goal was to make a multigun setup and my main difficulty was cycling light loads, and through many a trial and error have ended with: Go gun puck gasfixer gas plug lightweight recoil and trigger spring (css) krebs saftey g2 FCG SAW grip st