Maxaks

Arsenal or molot not bakelites 45 rd for my rpk

Fast shipping good communication items as descibed Thanks

Pm sent

Ill take them

It's a tromex modified trigger group. I got the instructions to modify the drum but I didn't know if I Took a little more down on the sides if it would raise the round a little higher for easier feeding when I say sides I mean the part that touches the bottom of the receiver I guess I will just go shoot the bejesus out of it and worry about it later Thanks

It is converted. Gas ports were opened up all parts beside conversion parts are stock. I had it set on 1 because it wasnt ejecting shells all the way on 2. Stock mag worked well previously I didn't take it today. When the bolt comes forward the round gets bound up and does not come off the ramp right. Rounds are hard to load and unload out of drum mags easier but still a Lily bit of trouble loading and unloading. It functioned very well before the conversion and after with the factory mag Thanks

I just got back from shooting my s12 I have a promag 20rd drum and a sgm 10rd. Both are new Both of them were not feeding worth a poppy gun has only been fired approximately 50 times never with these mags until today. The bolt was stopping at the shell not advancing it to the chamber. Do I need to do more filing on the sIde of the mag? They were remington sluggers

So I did a search on the forumn and found some mixed feelings about one of the places are these issues still current? Is one better then the other suggestions

Where do you get the bullpup conversion kits? Thank s

Fast email response great products all around a+

I started converting my 762 got all my parts from css started with the bullet guide, broke the drill bit they sent broke when it started coming out the bottom anyway got it out and got the hole clean. Question is does anybody have suggestions on a wrench for the die what to use, where to get one I tried using pliers but it did not work well so I quit before I f'ed it up. Question 2. I got a bolt on lower hand guard retainer it does not fit for shit .673 s the barrel diameter. The inside of the retainer is more oval shaped .586 and .650 these are the measure ments all the way tight. What sho

I wanted u.s. So I had all 6 compliance parts

The other day I seen css had the russian red stock set in stock... after two days of counting my pennies I went to order them and they were out of stock... Shouldve jumped faster

I will take the trigger, trigger guard and internal receiver block if you want to seperate

I have one on a 74 I like it alot another good one is mojos microclick? I have two of those one on a 308 and one on a 47 the krebs looks almost original that is why I like that one