vaglocker 0 Posted April 24, 2008 Report Share Posted April 24, 2008 It seems that on all the forums I've looked at they say to convert to "Evil" AK configuration you can only have a max on 10 imported parts. So I decided to take a look at the text on the ATF site and it says: "Further, an acceptably redesigned semiautomatic copy of nonsporting firearm must be limited to using less than 10 of the imported parts listed in 27 CFR 478.39©." The list of imported parts is the usual barrel, receiver etc.. Here is a link to the complete document ATF link So a reasonable person would assume that less than ten means 9 or less. So which is it? I'm in the process of planning my 308 conversion, and starting with the stock rifle (14 parts) was going to lose 4 parts: trigger, disconnector, hammer, and butt stock. This would leave me with 10 foreign parts. Is this legal or not? Help! Quote Link to post Share on other sites
vaglocker 0 Posted April 24, 2008 Author Report Share Posted April 24, 2008 Alright, so I'm an idiot . I just took the time to read the whole document. It appears that converting an acceptable firearm (stock Saiga) is different (10 or less foreign parts) than building an evil gun from scratch (less than 10 foreign parts). Quote Link to post Share on other sites
captzeno 5 Posted May 2, 2008 Report Share Posted May 2, 2008 All my Mags have Hesse floor plates. I like to throw a cheap easy US magazine floorplate in the mix just for one extra ace in the hole. (nine foreign parts total) Quote Link to post Share on other sites
t_broom 0 Posted May 5, 2008 Report Share Posted May 5, 2008 All my Mags have Hesse floor plates. I like to throw a cheap easy US magazine floorplate in the mix just for one extra ace in the hole. (nine foreign parts total) Where can I get floorplates for my S-20? Need Compliance help Thanks Quote Link to post Share on other sites
nalioth 405 Posted May 5, 2008 Report Share Posted May 5, 2008 All my Mags have Hesse floor plates. I like to throw a cheap easy US magazine floorplate in the mix just for one extra ace in the hole. (nine foreign parts total) Where can I get floorplates for my S-20? Need Compliance help Thanks You are asking in the rifle forum. I'm not aware of any US made floorplates (or any other mag parts) for the Saiga 20. Rumor has it, 10 rounders for the S-20 that are made in the USA will be available in the next few months. Quote Link to post Share on other sites
scor5150pio 0 Posted May 5, 2008 Report Share Posted May 5, 2008 Crap!! I hopew you're kidding about the 10 rd mags for my S-20! I can't afford any more toys right now!! I just shot my wad on theses damn guns and all this other crap! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.