BitBasher 11 Posted November 24, 2010 Report Share Posted November 24, 2010 The new hammer is the one on the right with the pointy shaped protrusion on the top of where the hammer pin goes through. This protrusion makes it so the hammer will not fall all the way and hits the frame of the gun. Is this normal? The photo below is my old hammer that doesn't reset properly in the disconnector next to my new hammer that won't rotate freely. Thanks in advance. Quote Link to post Share on other sites
Paulyski 2,227 Posted November 24, 2010 Report Share Posted November 24, 2010 (edited) The new hammer is the one on the right with the pointy shaped protrusion on the top of where the hammer pin goes through. This protrusion makes it so the hammer will not fall all the way and hits the frame of the gun. Is this normal? The photo below is my old hammer that doesn't reset properly in the disconnector next to my new hammer that won't rotate freely. Thanks in advance. Yes that's normal. AKs don't have the part that that point you circled will hit on the S-12, so you must remove the circled part for the S-12. If you want to profile the hammer face, just de-horn it a touch, don't remove nearly so much off the face. Also, you will have to modify the BHO side of the axis to use your BHO, unless you just toss the BHO, then keep the axis how it is. Edited November 24, 2010 by Paulyski Quote Link to post Share on other sites
BitBasher 11 Posted November 24, 2010 Author Report Share Posted November 24, 2010 (edited) Okay, so I will need to round off that nub and shorten the BHO on the side of the BHO. I wasn't planning to really reprofile the hammer at all, just polish it while taking off as little as possible. Thanks for the reply. Edit: In retrospect is there anyone out there that will sell me a hammer, properly polished and finished with the minimum metal removed from the face as possible, that will work in a saiga 12 as a drop in with a BHO? I'm more comfortable having someone else to this than me sitting here with a dremel. Edited November 24, 2010 by Bitbasher Quote Link to post Share on other sites
Cobra 76 two 2,677 Posted November 24, 2010 Report Share Posted November 24, 2010 You have a PM.... Bitbasher just send me your address man. Quote Link to post Share on other sites
BitBasher 11 Posted November 24, 2010 Author Report Share Posted November 24, 2010 Thread over, thanks for the help everyone. Quote Link to post Share on other sites
goldenpony 61 Posted April 21, 2014 Report Share Posted April 21, 2014 Okay, so I will need to round off that nub and shorten the BHO on the side of the BHO. I wasn't planning to really reprofile the hammer at all, just polish it while taking off as little as possible. Thanks for the reply. Edit: In retrospect is there anyone out there that will sell me a hammer, properly polished and finished with the minimum metal removed from the face as possible, that will work in a saiga 12 as a drop in with a BHO? I'm more comfortable having someone else to this than me sitting here with a dremel. I would like to have seen the answer to this question. I have the same concern. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.