scattergun10 125 Posted September 17, 2014 Report Share Posted September 17, 2014 I know for the Saigas the G2 hammer where the axis pin goes needs to have a little material shaved off to clear the BHO lever.(correct?) Since the Veprs don't have a BHO, does the G2 more or less drop-in right out of the box? Quote Link to post Share on other sites
warthog984 1 Posted September 19, 2014 Report Share Posted September 19, 2014 Drops in without any mod on VEPR rifle.. The only caveat is the VEPR 12. Quote Link to post Share on other sites
liberty -r- death 1,445 Posted September 21, 2014 Report Share Posted September 21, 2014 Yep, drop in for rifles. At least 5.45, 5.56, 7.62 rifles. I can say those work as a drop in from experience. Quote Link to post Share on other sites
adjc 171 Posted September 21, 2014 Report Share Posted September 21, 2014 on the v12 i used the factory hammer with the g2 kit, seemed like the US hammer was hanging up when bolt was cycling. have not had any problems with the pull, it is just as smooth as my rifles with the complete g2 kit. by doing this you lose the 3rd compliance part but that can be made up with other parts. Quote Link to post Share on other sites
Cobra 76 two 2,677 Posted September 24, 2014 Report Share Posted September 24, 2014 Or the G-2 hammer can be re-profiled and polished so it's much nicer than the factory hammer and you don't lose a compliance part. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.