skydancer
Member-
Content Count
14 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout skydancer
-
Rank
Member
-
http://www.skbcases.com/sports/product/sho...stoloptics.html Part number 31-1209. I bought this case at Sportsman's Warehouse for $69 + tax. It fits the MD drum mag perfectly.
-
Insert a sturdy wooden dowel, 1/2" diameter or larger, from the breech end and tap the dowel with a hammer to knock out the "hockey puck". This works well, I also spray some CLP on the "hockey puck", too. I got this suggestion from the Tromix website.
-
Try this. http://www.fseusa.com/product_info.php?cPa...14accc83edf6ac2
-
See if this helps. This pad fits the standard stock that was on my Kreb's custom S-12. It also fit the stock on my Arsenal AK-47. http://www.fseusa.com/product_info.php?cPa...14accc83edf6ac2
-
I used the Tapco T6/M4 recoil buttpad on my T6 stock, and it works very well.
-
The Tapco T6 stock for stamped receivers fit my Saiga 12. There was a space between the bottom of the stock and the receiver, so I put in a .030" steel shim with hole for the screw to fill the space. I added a Tapco rubber recoil buttpad. If you are interested, I put an M4 cheek piece on the stock from Bushmaster/ , and added a scope mount from K-Var so I could add an Eotech sight. I am happy with the results.
-
I got my S12 from Krebs. I have been happy with it. http://www.krebscustom.com/
-
I have ordered a Vltor stock for my Saiga 12 from Krebs Custom. Check it out. It is for AK47's on the Vltor site. http://www.vltor.com/ See accessories and adapters.
-
Check out Krebs. I just bought my first Saiga 12 from them. I shot it today for the first time. After I set it to position 2 for my Winchester heavy target loads, 7-1/2, it worked fine. http://www.krebscustom.com/
-
Thank you, Juggernaut. I have learned a lot about Saigas from this board.
-
Checking the first couple pages of a forum for threads on the same subject is appreciated, encouraged, and in fact expected. BattleRifleG3, thank you for the constructive criticism. I did a poor job of looking. I shall strive to do better in the future.
-
Has anybody seen one of these drum mags? http://www.wraithmaker.com/