Beowulf47
Member-
Content Count
24 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout Beowulf47
-
Rank
Member
Profile Information
-
Gender
Male
-
Look at PrimaryArms. Still Chinese, but good stuff. Questions.... Do you really need three different sights on one gun? What kind of OPs are you planning on running? with the scope that i have now, it is very hard to find a target within about 25 yards, as the scope blocks the irons. but i also dont want to lose the longer range capacitys of the centerpoint I have seen 2x red dots and they are ok at least. This just seems contrived and heavy. What rifle you mounting it on? The Nikons are very good for the money, good glass. Anything over 4x makes short range a bit tunnel vis
-
Look at PrimaryArms. Still Chinese, but good stuff. Questions.... Do you really need three different sights on one gun? What kind of OPs are you planning on running? with the scope that i have now, it is very hard to find a target within about 25 yards, as the scope blocks the irons. but i also dont want to lose the longer range capacitys of the centerpoint
-
right now i just have a centerpoint scope, so i might just get a mount that slips over the scope and mount a higher quality red dot on that.
-
So i looked around a little more, here's a simaler one on Amazon, its a TacFire: http://www.amazon.com/TacFire-illuminated-Reticle-Tactical-Adaptor/dp/B00L2Z8S5Q/ref=sr_1_6?ie=UTF8&qid=1414083038&sr=8-6&keywords=red+dot+combo+scope i dont want to spend more than $175 right now.
-
Anyone have any experince with these? http://www.ebay.com/itm/291179177737
-
What can you do to a Saiga?
Beowulf47 replied to PvtPyle's topic in Second Amendment, 922r & the law
New York sucks... -
Check out this one: http://centerpoint.crosman.com/scopes/adventure/CP395RG I'm gonna order one for my S308 in a few weeks.
-
No, not if you put a jam-nut on.
-
Does anyone have blueprints/drawings for the original wood buttstock? I can't find them any were!
-
I'm a knife maker, and run a small welding shop, so I have most every tool, Except a lath and end-mill. So that should be pretty easy.
-
Yup, that's what I've been hearing.
-
I just picked up a 22" about two weeks ago and I got it $575. Stock.
-
Has anyone tested the difference between the 22, 18, 16"? @ 100, 300, 500yds?