toshbar 36 Posted June 7, 2010 Report Share Posted June 7, 2010 Lets see all those who have customized the stock saiga forend/hand guard and hear how you did it. I would like to vent/shave the front down of mine and would like to see some that have already done it and figure the best way to go about it. I've been searching the internet for this for the past 5 months and finally joined tonight so I can ask now! Quote Link to post Share on other sites
Avtomat 3 Posted June 7, 2010 Report Share Posted June 7, 2010 (edited) Here is a simple start, I plan to add some ventilation. I used blue tape to lay out the cut lines and used a Dremel cutting wheel and a fine tooth hobby saw. A flat piece of glass with several grades of sandpaer finish with 1200 as the last, while sanding wet. The cloth buffing wheel on the dremel works as the last step. A very small amount of Armor All helps Edited June 7, 2010 by Avtomat Quote Link to post Share on other sites
Spikester 93 Posted June 8, 2010 Report Share Posted June 8, 2010 Holes were easy, layed them out on tape 1 inch apart and drilled and chamfered them with a 90 degree countersink. Sling is an SKS, mag is a $10 surplus from AIM. Quote Link to post Share on other sites
denden 16 Posted June 8, 2010 Report Share Posted June 8, 2010 Slots and a "nose job." Quote Link to post Share on other sites
Bossman 1 Posted June 12, 2010 Report Share Posted June 12, 2010 Nice Water Buffalo Spikester. Quote Link to post Share on other sites
Bigtwin 219 Posted December 6, 2010 Report Share Posted December 6, 2010 Uploaded with ImageShack.us Just wanted to say thanks for the inspiration! Quote Link to post Share on other sites
Zambidis 90 Posted December 6, 2010 Report Share Posted December 6, 2010 If anyone has modded one to look decent with an ultimak gas tube I'd love to see it. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.