Crackbone 0 Posted June 11, 2010 Report Share Posted June 11, 2010 Hello, I've recently completed the conversion of my Saiga-12, but I can't reinstall the safety-lever. The trouble seems to be that the BHO prevents the installation of the safety-lever. Is there some special technique that has to be used to reinstall it? I've tinkered with it for hours without success. Thanks Quote Link to post Share on other sites
corbin 621 Posted June 11, 2010 Report Share Posted June 11, 2010 I ran into the same problem. The solution is to slightly notch the BHO to allow the safety to pass, like this: click on pic for link. Quote Link to post Share on other sites
skiboatsp 111 Posted June 11, 2010 Report Share Posted June 11, 2010 Check out Also you can notch he safty lever Quote Link to post Share on other sites
evlblkwpnz 3,418 Posted June 12, 2010 Report Share Posted June 12, 2010 (edited) I ran into the same problem. The solution is to slightly notch the BHO to allow the safety to pass, like this: click on pic for link. I've modded one like this.... works like a charm. As long as you have a good 'eye' you should be able pull it off. Just don't get carried away. While you have it out, it may be a good time to take a little off of the BHO 'button'. Edited June 12, 2010 by evlblkwpnz Quote Link to post Share on other sites
TacSat 90 Posted June 12, 2010 Report Share Posted June 12, 2010 Excellent timing for this thread. just ran into the same problem. did not want to take down again. already lost one bho spring. with alittle patience and a steady hand it can be done in the weapon. dremal is a great tool. worked like a charm. thanks.. Quote Link to post Share on other sites
presto_z 125 Posted June 13, 2010 Report Share Posted June 13, 2010 ive done several conversions and have not notched a safety lever yet.. just put the safety lever in before the BHO Quote Link to post Share on other sites
Coils 2 Posted June 13, 2010 Report Share Posted June 13, 2010 What he said, put the safety in first. Quote Link to post Share on other sites
TheKid 3 Posted June 13, 2010 Report Share Posted June 13, 2010 Unless you are using the flat pin retainer, then it has to go in last..... Quote Link to post Share on other sites
SKYWLKR 0 Posted June 14, 2010 Report Share Posted June 14, 2010 Roll the BHO arm up towards the top and front of the receiver... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.