hawaii five-0 0 Posted May 15, 2011 Report Share Posted May 15, 2011 Gonna do a bullet guide install and was wondering if anyone has had problems with theirs coming loose or stripping out.How about welding it in? Quote Link to post Share on other sites
XXasdf 29 Posted May 16, 2011 Report Share Posted May 16, 2011 (edited) I used blue loctite on the screw after drilling and tapping. It has not backed out or come loose after installation and I've ran about 400-500 rounds through it. Also I have a flat trunion. Edited for typos Edited May 16, 2011 by XXasdf Quote Link to post Share on other sites
n102788 6 Posted May 16, 2011 Report Share Posted May 16, 2011 Loctite after drill and tap over 3000 rounds no movement at all. Quote Link to post Share on other sites
grendelz 61 Posted May 16, 2011 Report Share Posted May 16, 2011 Ditto, over 200 rounds and no movement in both my 223 and 7.63X39 Quote Link to post Share on other sites
Foxtail207 23 Posted May 16, 2011 Report Share Posted May 16, 2011 I saw a post where the BG was installed with JB weld, not even drilled and tapped. Not sure how that worked out. Quote Link to post Share on other sites
unclejake 428 Posted May 16, 2011 Report Share Posted May 16, 2011 Flat trunnion in the x39, round in the .223.....blue locktite, and no problems. Quote Link to post Share on other sites
stnls1911 55 Posted May 16, 2011 Report Share Posted May 16, 2011 I drilled the hole slightly off-center,so I used a lock-nut on the bottom side; zero problems after a few hundred rounds. Quote Link to post Share on other sites
ninja steve 0 Posted May 17, 2011 Report Share Posted May 17, 2011 Broke the tap so I just jb welded it. 1000ish rounds no problems. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.