jbmidnight

You clean a bore of a S12? I guess if you do from action to muzzle, if you go opposite you just dump shitty cleaning solvent into your action dept.

Federal Bulk for me has always been better than the Winchester. The absolute worse I have had is Winchester low recoil. Try the Fed on setting 2.

totally forgot about cutting it down. Thanks Gunfun for pointing it out. Totally forgot about that option. This forum rawks

as for magazines, 8 or 12, go in between and get 10. The 12 are obscenely long. Best bet would be to order a MD20 Drum.

Went to the range today. 200 rounds of Federal Bulk from Wally World and only one FTL and that was the last round on my MD drum. All the Surefire mags without a hiccup. So happy. Thanks all for chiming in with advice and opinions. They were all appreciated.

Damn them are some nice weapons

haven't put one on yet. Its just a cut 18.5" bbl at this moment. Not sure if I want to add one now

Zambidis I fail to see any admission if you are implying I am guilty of something. As I am sure you can read since you quoted it I cut the bbl to 18.5 from the closed bolt. So that is legal from anyway you look at it, Even w/o the brake installed.

Of course he would say all that. Thats like calling a Dr saying you have a medical problem. No matter how minimal they will say to go to the ER.

Well i took Azrials advice and slowly took my time with a good pipe cutter. Approx 6 minutes it took and it is exactly 18.5" from closed bolt face. no indentations on inside of bbl as I took my time cutting. Just a nice even cut with no bad choke from rushing it. Used a conical stone to smooth out the inside and going to use blue wonders cold blue but in black for coloring it. Thanks everyone for chiming in and suggestions. This was before now after

Is the s12's bbl carbon steel?

Thanks Azrial

I dropped the tape measure down my bbl and its 24.5" to the closed bolt. this is with my birdcage brake on. I want to cut it down but worried about possible rust/corrosion. question #1. Can i cut it to where it is 18.5 with brake permantly installed or does the bbl need to be 18.5 w/o brake? #2. I was going to use a pipe cutter just to lightly score bbl to get a good guide line then use saw. Any recommended blade over others or any hacksaw blade for metal? As for threading I was going to order the threader from CSS. Thanks in advance for all your help, you guys kno

Try polishing the bolt and rails.

10 round clip with 2 3/4" with 00 buck and #4 shot alternating. The wife can shoot that with no prob and little recoil to stay on target or multiple targets for when I'm not home. Also do not have to worry about going thru walls and into a neighbors house like a magnum slug would.